cp-pvc

water stop

special feature

  • Chemically inert.
  • Highly resistant to acids & alkalis and waterborne chemicals.
  • Does not fatigue as a result of repeated flexure.
  • Retains elasticity through a temperature range of -1C to + 80C
  • Easy to weld & join.
  • Multirib section provide excellent water check.

CP  Waterstop

are high grade Polyvinyl Chloride waterbars used to seal construction and expansion joints in concrete structures and are available in different size and section.

USED & ADVANTAGE

CP Waterstop are used to prevent the passage of water through expansion and construction joints in concrete. The selection  of  the waterbars is dependent on the type and size of joint.

INSTALLATION

CP Waterstop must be installed so that they are securely held in their correct position while the concrete is being poured. The concrete must be fully compacted around the CP Waterstop to ensure that no air holes or porous areas remain. Where reinforcement is present,an adequate clearance must be left to permit correct compaction. Welding and installation of CP Waterstop shall always be coordinated with mould setting and laying of reinforcing bars for the best results.

PAKAGING : 25 metre rolls.

 

Test  Method                                               

Durometer hardness, ShoreA               71.6     ASTM D 2240

Tensile strength, kgf / cm2                   153.1     ASTM D 412

Elongation at break,%                          335.4     ASTM D412

Stiffness in flexure , kgf / cm2               41.9     ASTM D747

Density , g / cm2                                      1.32    ASTM D792

Dumbell center bulb type  6, 8, 9, 10 , 12   inch

water proof

related products