CP-plug
is hydraulic cement that is mixed with water to produce extremely rapid setting plugs.It stops leaks under pressure. CP-PLUG is ideal for repairing cracks in concrete or mortar, sealing joints between walls and floors below grade, sealing around pipes and conduits and setting anchor bolts and railings.
For plugging leaks
undercut or square cut surface rather than cut a v-groove. Cut out area to be plugged to minimum depth and width of ¾”. Flush away all cutting and dirt. Use immediately after mixing, work putty between hands until it begins to be stiffen – some heat will be developed. Force plug has set (about 2-3 minutes). Cut off excess plug flush with surface or leave recessed for cement coat waterproofing. For vertical cracks, start plugging from the top. After leakage has been stopped, apply cement coat waterproofing.
For anchoring bolts or metal posts
drill hole large enough, so that, there is minimum of ½” surrounding bolts or posts. Remove all the spoils from hole by blowing out or brushing.Dampen the surface and fill hole with CP-PLUG. Tamp firmly and keep moist for 15 minutes.The setting time of CP-PLUG varies with temperature. To hasten the set in temperature below 40o F, use heated mixing water. The dry powder material may also be heated up to 100o F.
Precaution
Keep out of reach of children. Keep in cool place. Rubber glove are recommended. If in contact with eyes, rinse with plenty of water and seek medical attention if irritation develops. If in contact with skin, wash immediately with soap and water. If swallowed, do not induce vomiting, drink milk and seek medical attention.
Technical data
